For customers with the switches that don't have areas and codes in the CDRs, and areas are to be loaded from files, it is possible to edit and add the
areas manually via the
Config: Objects ->
DST 1 codes table.
In the same fashion, one may now edit and add the SRC areas to the
SRC 1 codes table to get SRC area stats.
Additionally, any customer may load the second and third independent set of areas to the
DST 2 codes and
DST 3 codes table correspondingly.
For example, you can collect total stats by whole countries in addition to your standard areas by means of
DST 2 areas and, on the contrary,
collect more granular areas for some destinations by means of
DST 3 areas.
Each set consists of 2 tables:
- Areas - contains a list of area names.
- Codes - contains a list of prefixes with corresponding area names.
It is still possible to load areas to the
SRC 1,
DST 2 and
DST 3 tables from files by sending request to 5gvision support. After that you can correct
them in the usual manner.
In some cases if a switch doesn't have correspondence between customer/vendor IDs in CDRs and customer/vendor names you can use the
Companies table. It lets you load names to 5gVision so that the system displays names, not IDs in statistical modules.